Posted on

grow marijuana seeds indoors

The beauty of starting seedlings in the opaque cups is that you can see the root growth. Poke some drainage holes around the cup bases. It’s quicker to do the drain holes with the cups in a stack. As you finish each cup, slip it in the other end of the stack or you’ll waste crumpled up cups. Mix the potting soil with enough sand to give the fluffy soil more body. Add water gradually, mixing well to moisten.

How to Grow Your Own Cannabis Plants From Seeds

Takeaway: Back in the last millennium, before cloning swept the country like the hula hoop, people actually grew cannabis plants from seed. Primitive, huh? But where there’s a will, they’ll surely find a way. While that’s all changed now (hello, cloning!) you can only clone so many times before you have to buy more plants or get back to basics with seeds.

Growing from seed is all about the quality of your seeds. Plants will never be better than the seeds they grew from. Back in the day, there weren’t any seed shops, so seeds were saved from exceptional buds, but it was all a crapshoot with a lot of trial and error. Luckily, now we know better.

Starting from seed isn’t difficult and you don’t need to be an experienced gardener, but the process is a journey in stages, not a direct flight. Cannabis plants are perfect for growing from seed because they have a short life cycle. That being said, be prepared to check your plants every day for moisture, insects, diseases, nutrient deficiencies and light. If you can’t make the time and work commitment, perhaps you should forget the idea. Here’s my list of what I used for my first grow. Nothing high-tech—my grow room was a walk-in closet with louvered doors and a clothes bar to hang my lights.

  • A four-foot table or two sawhorses with plywood on top
  • A piece of thick plastic or a waterproof tablecloth for spill protection
  • Potting soil for seedlings
  • Clean sand
  • Seeds (of desired strain if purchasing)
  • Five-gallon pail for mixing soil
  • A four-foot shop light with chains and S hooks
  • One full-spectrum red fluorescent grow light
  • One regular white fluorescent tube bulb
  • Light timer
  • Five-ounce opaque drink cups
  • Eight-ounce drink cups
  • pH kit
  • Plant flats or trays
  • Plastic kitchen wrap

Best Lighting for Cannabis Seedlings

If you’re on a budget, fluorescents offer the biggest bang for your buck when getting light to you cannabis seedlings. Don’t forget to factor in the cost of electricity and bulb replacement. To make sure all my plants got an equal amount of light, I turned the trays 180 degrees every day. I especially liked the ease of raising the shop light one link at a time as the plants grew. You can maximize your light by using a room with white walls or surrounding your grow table with movable reflecting foil-covered cardboard or hanging sheets of Mylar—mirrors don’t work well for reflecting light.

Email Newsletter

Join thousands of other growers who are already receiving our monthly newsletter.

Germinating Cannabis

Mature cannabis seeds are dark brown, sometimes with swirly patterns or stripes. Discard immature pale or greenish-colored seeds. I’ve never started seeds in soil, preferring the Japanese method of “proving” seeds first; there’s no sense planting dud seeds. I germinated my seeds in a moistened, loosely rolled up paper towel on a plate in indirect light on the kitchen counter where I could keep an eye on progress. Keep the paper towel moist, but not lying in a puddle of water or the seeds will rot.

Some seeds germinate in a couple of days, while some take up to a week, depending on their temperature. It’s helpful to know that the seeds will produce male and female plants. Back in the Dark Ages, I always started 16 cups of seeds in hope of ending up with four females. That’s no longer a problem if you can buy feminized seeds, which are guaranteed to be females. I planted two sprouted seeds about one inch apart per cup because frequently one seedling will be bigger and stronger than the other. Go with the bigger one and pinch off the smaller one at the soil level.

The beauty of starting seedlings in the opaque cups is that you can see the root growth. Poke some drainage holes around the cup bases. It’s quicker to do the drain holes with the cups in a stack. As you finish each cup, slip it in the other end of the stack or you’ll waste crumpled up cups. Mix the potting soil with enough sand to give the fluffy soil more body. Add water gradually, mixing well to moisten.

Fill the cups with the soil mix and tap each cup a couple of times on the table to eliminate air pockets. Add more soil if needed, tap it down again to leave a half-inch space between the top of the soil and the rim of the cup. Repeat until all the cups are filled. Set up your grow table and lights. Ready? The table is all set. The lights are on. The cups are shoulder to shoulder in rows, waiting to fulfill their roles.

Transplanting Cannabis Seedlings

My tools of choice for planting were a small wooden matchstick and a wooden toothpick. I made two small holes with the clean end of the match about one quarter inch deep and a half inch apart and not too close to the side of the cup. I picked out two sprouted seeds at a time from the paper towel, careful not to touch the sprout, and dropped them into the match holes and used the tip of a toothpick to scuff soil into the holes, then lightly tamped the spots with one finger. Keep the remaining sprouted seeds covered so they don’t dry out. Repeat until all the cups are planted.

Put as many cups that fit into shallow flats or trays and then drape a long piece of kitchen plastic wrap over everything, tucking the ends under the trays to create a mini greenhouse. When this step is finished, the plants get to sunbathe under the lights for the next six weeks or so of the seedling phase.

In a few days, two primary leaves will appear and you can do your happy dance. Soon the next pair of leaves will appear and the first ones will drop off. If condensation forms under the plastic wrap, uncover the seedlings to release the excess moisture and then replace with fresh wrap. During the seedling phase, keep the soil moist but not wet and only water from the bottom from so the roots stretch down long and strong.

Water with a spray bottle until the first leaves appear, and then water from the bottom; the soil around the stem needs to stay dry to avoid stem rot. Fill pitchers or buckets with tap water and let sit uncovered until room temperature and the chlorine has evaporated into the air. Hard water is fine, but don’t use artificially softened water because it contains too much salt and other harmful additives.

I’m an organic gardener. While I don’t object to a little bloom booster to convince some reluctant annuals to step it up, I want everything that goes in my body to be as natural as possible. Plants need nitrogen to grow. When I had access to a mountain of free rotted horse manure, I fertilized with manure tea.

Throw a shovelful of manure in a bucket, fill with water, let it sit a couple of days and water with the tea. It worked fine for me. There are “hot” manures and “cold” manures. Hot manures have the highest nitrogen, but have to be aged. Cold cow manure has lower nitrogen but can be used hot out of the barn. Rabbit manure is cold, but some growers call it nitrogen on steroids. If slogging around in barnyards doesn’t appeal to you, you could use fish or seaweed emulsions or any of the other excellent natural fertilizers available at your local hydroponics supplier.

Check your soil pH regularly. Plants grown in soil like a pH about 7. If your soil drops below 6, add a light sprinkling of ground limestone before watering. If the soil is above 8—too alkaline—sprinkle around a concoction of cottonseed meal, lemon peels and ground coffee.

For repotting, discontinue the plastic wrap when the third set of leaves appear. When you see that the roots have reached the bottom of the cups, it’s time to repot the little darlings into the eight-ounce cups. In my experience, the plants do better stepping up to the bigger cup instead of going directly into three-quart pots. Repotting can be tricky, so take your time here. The plants shock easily with too much jostling or rough handling. Get the larger cups ready, poke the drain holes and fill with enough soil mix so the seedlings will be at the same depth as in the first cups. Before removing from the smaller cups, lightly water them so everything stays together.

Tip the cup upside down in your open hand with the seedling stem between your fingers. Gently squeeze the sides of the cup with your other hand and the seedling will drop out in one piece. Don’t pull it out by the stem! Place the seedling in its new home, filling around it with more soil, and make sure it isn’t deeper or shallower than in the smaller cup. This is important. Compress the soil lightly for any air pockets.

Entering the Vegetative Stage

During the vegetative phase, leave the lights on 24/7 and as close to the leaves as possible without touching. If the lights are too high, the stems will grow weak and spindly. You want the plants to remain compact. When your plants really take off, they may grow an inch a day. Keep a sharp eye on the distance between the tops of the plants and the lights. Fluorescents are cool and won’t burn the leaves, but keep adjusting your lights upwards to stay ahead of the growth.

Rotate your plants so they all get enough light. When plants are starting to bud, rough handling or a sudden change in temperature or light will drive them into shock. When you see your plants are beginning to outgrow the cups, it’s time to pot up again, this time to three-quart containers commonly found at nurseries. Always wash used pots in hot soapy water before reusing.

Sexing

Toward the end of the vegetative and budding phase, you’ll be able to sex your plants. Males have two pollen-filled sacs that are easy to see and females have a pair of white V-shaped hairs. One male plant is enough to pollinate all your females so they produce seeds. I didn’t grow for seeds, so I quickly yanked all the male plants. Male plants are low in THC, are harsh-tasting and give many people a massive headache. Unpollinated females produce more flowers, buds and THC.

For even more plants, remove the unproductive lower stems and leaves on your plants, and then make two or three shallow downward slices on the main stem with a clean blade and insert a graft slip dipped in root stimulant in each cut. Put a small piece of tape around the cuts. The grafts can be other varieties, not just the same as the host plant. Soon you’ll have new growth from all your grafts, giving you maximum yields.

Grow marijuana seeds indoors
Carefully place your cannabis seeds between wet paper towels and place them in a sealable plastic container. Aim for high humidity levels inside the container, temperatures between 20-25 °C, and moist, but not overly wet paper towels. Check moisture and humidity levels regularly. Don’t completely close the container and allow some air exchange. This happens at a dark place.

Rookie Guide: 3 Steps to Master the Seedling Stage

Mastering the delicate seedling stage is crucial to grow strong and healthy cannabis plants. Read this blog for further information on how to cultivate cannabis from seed to seedling.

CONTAINER AND GROWING MEDIUM

Before germinating our cannabis seeds, we make up our mind about containers and soil, assuming most rookies prefer soil due to simplicity. At this point, we already need to differentiate between autoflowering – and feminized/regular seeds.

A. POTS FOR AUTOFLOWERING SEEDS

Growers of autoflowering varieties will get best results when they plant the seed directly into the final pot, and need to pay very close attention to seedlings for the first three weeks. Mistakes in the vegetation period of autoflowering strains have fatal consequences, meaning low yields. Depending on the strain and growing method, pot sizes ranging from 5-15 liter can be used. The size of the pot will have an influence on the size of your plants, on yields, and on the frequency you water your plants. Tip: Airpots allow more oxygen to get to the root system and will boost vitality and final yields.

B. POTS FOR FEMINIZED SEEDS

Feminized- and regular cannabis varieties give growers the possibility do decide when the vegetation period ends, and the flowering period starts. This is why transplanting “feminized” seedlings is not such a big concern, in contrast to autoflowering strains. When a few days are lost due to stress recovery of the plant, growers simply increase the time-span of the vegetation period and compensates the loss of growth. Internet forums and grow reports can help to get you an idea what works best in terms of pot size(s) matching your setup.

C. GROWING MEDIUM

High quality organic soil that is “light” when it comes to pre-added nutrition works best.

GERMINATION TECHNIQUES

There are basically two different techniques that are commonly used to germinate cannabis seeds.

A. THE WET PAPER TOWEL METHOD

Carefully place your cannabis seeds between wet paper towels and place them in a sealable plastic container. Aim for high humidity levels inside the container, temperatures between 20-25 °C, and moist, but not overly wet paper towels. Check moisture and humidity levels regularly. Don’t completely close the container and allow some air exchange. This happens at a dark place.

B. GERMINATING SEEDS IN WATER

Simply drop your seeds into a glass of drinking water and wait 24-48 hours until seeds have cracked. Wait until you see the first few millimeters of the root, and make sure water temperatures are between 20-25 °C. Place your cup somewhere light doesn’t reach it.

ENVIRONMENT: LIGHT, HUMIDITY AND WATERING

After seeds have germinated, it’s time to plant them into the pots. Plant the seeds just 3-5 millimeters below the surface of the earth, ideally with the tiny root facing downwards. This can help to avoid time-loss and seeds don’t have to figure out how gravity works.

A. LIGHT

It’s not necessary to use your powerful HPS or LED the first 10-14 days. CFL’s with a blue light spectrum (daylight/coolwhite) will get you very good results. Either built your own light fixture using T5/T8 sockets or buy 23-30W CFL’s with the standard European E27 lamp socket. Compare different bulbs and choose the ones with highest lumen output.

B. HUMIDITY

Aim for humidity levels of approximately 70%. Small propagators can be an option if you start in very small containers but autoflowering growers planting in final pots need to monitor, and eventually raise, the humidity inside the grow room.

C. WATERING

This is by far the most important part when growing seedlings, and cannabis in general. Don’t overwater your plants due to overly high levels of affection for your cannabis plant! The root system has no motivation to grow if it’s constantly flooded with water. You need to find your individual rhythm or cycle between wet and dry. This will come over time and your seedlings will thrive if you pay close attention to watering. Remember, less is sometimes more!